![]() Thank you in advance for any assistance in this matter. Then use Map Network drive in computer on your computer using \\ip address or NAS name\share name. Is UPNP enabled on the router and on the computer you need to make sure netbios over TCPIP is enabled and also enable it on the NAS check manual for the NAS. I would like to just get the chassis working again on my LAN. Re: Can't access iomega NAS, network issue Everything is in the same subnet from what i see. It doesn’t necessarily have to be the same “OS” / firmware as before, anything will do. Please see below link for reference to my drive. I would like to be able to “revive” my Iomega Media Network Hard Drive. I would have thought that the “OS” / firmware would be installed on a chip on the chassis somewhere instead of it being on the hard drive itself.Īnyway, this brings me to my question. ![]() I went and a bit of research and due to the fact that the new drive doesn’t have an “OS “ / firmware installed on, it doesn’t pick it up. After doing so and connection drive NAS drive up to the network, it doesn’t seem to find anything. I have gone out and purchased a new drive to replace the faulty one. As Murphy's Law goes the hard drive has subsequently failed on me and it is out of its warranty. I purchased myself an Iomega Media Network Hard drive a while ago.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |